How To Extend Wireless Coverage Through Netgear EX7000 ?

There is no doubt that the need for wifi connectivity in every single corner of our space is an absolute necessity. As everything from work to entertainment requires high speed wifi connection. This is not possible when you rely solely on the routers. Because routers are meant to cover limited space and can handle few devices only. So if you want seamless connectivity then investing in Netgear ex7000 setup is a practical decision. If you decide to buy one or already got your hands on it then this blog-post will lend you a helping hand in conducting an errorless Netgear ex7000 setup. So without unnecessary delay, check out the steps for the easiest and the convenient wifi protected setup method. 

Setup Begins

First up, unpack the ex7000 package. Inside you’ll find antennas and your ex7000 signal booster. Remove the cap of antennas. Thereafter connect them to the signal booster’s connector. Turn them clockwise to attach them properly. 

✓ Activate The Signal Booster 

After you properly attach the antennas, take the extender into the same area as your router. Now link the ex7000’s power adapter to the wifi signal extender. Thereafter connect it to the switch board. Turn it on. Now the Netgear ex7000 setup requires a few minutes to start up. So allow it that time. 

✓ Connect 

Moving further, it’s time to push the extender’s WPS button. Once you do it, the link rate LED as well as the device to the extender LED light lights up. As you see the glowing light, press the router’s WPS button. After the configuration completes, the 2.4GHz link rate LED turns green. It indicates successful Netgear ex7000 setup. 

Now if your router supports 5GHz band then to extend its coverage, repeat the above written step again. With this your 5GHz link rate LED will also light up. 

✓ Relocate The Netgear EX7000 Setup 

After proper synchronization you can unplug the ex7000 and place it more thoughtfully to eliminate the dead zones. You should plot it halfway from the router and the area with connectivity issues. The area that you choose must receive more than forty percent signals from the router. Because effective and seamless communication between the router and ex7000 is extremely crucial for the signal booster to work in your favor. Additionally, plot the Netgear ex7000 setup away from metal and electronic objects. As these objects can create a hurdle in proper working. 

As you plot the ex7000, replug it and turn it on. All the front interface lights should glow green. If you see a red indicator on any of it then it suggests poor connection. In that case you need to reposition your ex7000 more strategically. Keep repositioning it until the indicators glow green. 

Finally, fetch your smartphone. Link it to the new network. Your new network identity is similar to your router’s SSID; it just has EXT at its end. The security key also remains the same. Lastly, test the connection by streaming any high definition content.